[Packaging specifications] 10KG
[Shelf life] 4 years
【Product Introduction】
This product forms a long-lasting and dense film on the surface of wood, which hinders the evaporation rate of water, reduces the loss of water in exposed wood, and avoids deformations such as end cracks, surface cracks, internal cracks, wheel cracks, etc. It is a more practical wood anti-cracking agent and end crack sealant on the market.
【Features】
1. Good anti-cracking performance, it can deeply react and seal wood, stabilize stress, and inhibit end cracks, surface cracks, internal cracks and dry ring cracks;
2. Good shaping effect, deep penetration of nanomaterials, excellent sealing, reducing internal stress of wood and inhibiting wood deformation;
3. Preserve the surface texture of wood, enable paint-free surface decoration of wood products, and enhance the natural texture of wood products;
4. Enhance the wear resistance and hardness of the wood surface, neutralize low-density tree species, and make up for the loss of mechanical strength of carbonized wood;
5. Improve the mechanical properties of wood such as bending and compression resistance, and the compensation effect on the later strength of carbonized wood is particularly obvious;
6. Anti-corrosion, mildew-proof, and insect-proof, which can provide auxiliary protection for outdoor wood products and inhibit the growth of moss and moss;
7. Enhance the acid, alkali and high temperature resistance of wood, and achieve a sealing effect even without painting protection;
【Scope of application】
This product is suitable for newly felled logs, newly sawn boards, laminated lumber, floor base materials, etc.
【How to use and dosage】
1. Method: This product can be used by brushing, roller coating, spraying, etc. In order to achieve excellent results, the cutting surface should be as smooth as possible. For rough surfaces, spraying is more uniform than brushing. You can use a brush, roller brush or sprayer. If you use a sprayer, the wood end anti-cracking agent emulsion is very thick, so the spray hole should be large enough, with a diameter of about 0.55mm.
2. Dosage: When painting on logs, sawn timber, laminated lumber, and floor base materials, if the paint does not drip, it means that the dosage is not enough. If it drips a little, it will be good. If it drips, it means too much. For those precious logs, the anti-cracking agent should be applied thicker. For logs with a diameter of less than 60 centimeters, it should be applied until it drips a little. For logs with a diameter of more than 60 centimeters, the anti-cracking agent should be applied thicker, that is, it should be applied twice within 15 minutes.